Box for veggies

here's sprocket hanging out by the wood that I was laying out to see if I had everything we needed. There's (8) 8' x 6" x 2" uncut boards for the long sides , (2) 8' x 6" x 2" cut to (4) pieces for the short sides, (2) 10' x 6" x 2" cut with 45 degree angles cut in the ends for the top lip, (2) 8' x 6" x 6" cut with 45 degree angles for the short sides of the top lip. (2) 8' x 2" x 2" cut to 8 pieces for the corner posts. Then finally some 8' x 1" x 2" for the inside bracing and slots. A few extra pieces from the 2"x2" were used for support of the lip.
Here's the removable divider made out of some thin scrap. We didn't worry about measuring too perfectly because no one will see the insides anyway, but we tried to center things for even support.
this is to show the support we included to keep the lips on top reinforced.
and here it is pretty much finished, we propped it up so it could be stained easier.